|
Post by cleobis on May 25, 2005 17:52:14 GMT 1
Hi, I have the following hardware:
A microsoft FF whell serving as the wheel and throtle and brake.
then, I have a saytek X45 to wich I've assigned to buttons for gear up and dwn
and lastly I have a thrustmaster ferrari non FF of wich I only use the throttle pedal as the clutch, so:
All is working fine the clutch works (though it only has a small travell) the gears work, all ok, BUT:
I'd like to use the clutch all the time to get the gears going, so I d/l this great prgm to see if I could do it, but it seems that I can't.
When I put the 2.USB in the shifter model and enable the clutch to bee allways needed, I can't get the gear in, it's stuck in neutral..I tryed to adjut the travel of the clutch but no luck...also tryed getting from 50% to 90% in the .ini file but nothing worked, also if I disable the clutch and keep the 2.usb in the shifter_model, the car gets the gears but only 3rd and 4th...
only when I put none there I can get it to work, but again I can put the gears without any clutch and that was not what I was aiming for...
So, the big question:
is it possible to get the buttons work like the shifter in sequencial?and if so, can I get my clutch to work?
thks
and sorry for the long post
|
|
|
Post by JSJ on May 26, 2005 11:00:16 GMT 1
|
|